Connecting The Signal Splitter - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
6 Wiring and Connecting

6.7 Connecting the Signal Splitter

Connect a relay cable to the connecter EXT I/F for the connection of the signal splitter (FCU7-HN387).
Skip (sensor) signals (refer to "Wiring and Connecting: Connecting the Skip Signal (Sensor)") and the signals from
manual pulse generator(s) (refer to "Wiring and Connecting: Connecting the Manual Pulse Generator") can be
connected to the signal splitter.
Install the signal splitter on a DIN rail.
R16NCCPU
EXT I/F
(Note) Neither the connector RIO nor TERMINAL of the signal splitter is currently available.
<Related items>
Cable drawing: "Cable: H010 Cable"
IB-1501452-C
NC I/F
H010
82
FCU7-HN387