Basic Position Alignment Method I - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
14 Setting the Position Detection System

14.1.1 Basic Position Alignment Method I

(1) Preparations
Set the parameters on the
[Abs.Posit.Param.] screen.
(2) Turn the power OFF and ON.
(Only when #2049 has been reset.)
The following are the operations on [Absolute position setting screen].(Select [Mainte] -> [To Abs pos])
(3) Select the axis set to type 2 on the
[Abs.Posit.Param.] screen.
Select the menu [Axis select], enter
the axis name (#1022 axname2
(display axis name)) in the input area
and then press [INPUT].
(4) Select "HANDLE", "HANDL_AXIS", or
"JOG" for the mode selection of
machine operation switch.
(5) Confirm that the cursor is placed on
"Absolute posn set", input "1" in the
input area and press the [INPUT] key.
IB-1501452-C
#2049 type (absolute position detection type) = 2
#2050 absdir (basic point of Z direction) = 0/1
#2059 zerbas (select zero point parameter and basic point) =0
(position where the axis was stopped) (* 1)
The parameters other than #2049 type can also be set on [Absolute
position setting screen].
The input value is registered in the "Absolute posn set" area.
188
(marked point alignment method)