C80 Series Connection and Setup Manual
11 CNC CPU Initial Setup
11.2 Selecting NC System Type and Display Language
Perform the parameter setting for the CNC CPU module from the "CNC monitor 2" of GOT.
(1) Select [Mainte] tab and then select [Param] at the bottom left.
(2) Select [Para No search] in the middle at the bottom, enter "1043" in the setting area and then press [INPUT] key.
Enter the password for the machine parameter and then press [INPUT].
(Note 1) When entering "A", press the shift key before pressing [A]. Do not press both keys at the same time.
(Note 2) The password will be displayed as "*****".
(3) Set the language No. ("1" for Japanese) you desired to display in the setting area of "#1043" and then press [INPUT].
(4) Select [Para No search], enter "1163" in the setting area and then press [INPUT].
(5) The cursor will move to the "#1163 No rio (RIO connection detection invalid)".
(6) Enter "1" in the setting area and press [INPUT]. (0: valid, 1: invalid)
(7) Select [Para No search], enter "26750" in the setting area and then press [INPUT] key.
(8) Enter "2" (for CPU: 2 units) in the setting area and then press [INPUT] key.
153
IB-1501452-C