Mitsubishi Electric C80 Series Connection And Set Up Manual page 91

C80 Series Connection and Setup Manual
5 Installation
(6) Be sure to use the fixing screws and fix the basic base unit on the panel to avoid an operation failure due to
vibrations.
Install the basic base unit in the following procedure.
(a) Fit the two fixing screws for top of the basic base unit to the panel.
(b) Place the right-hand side notch of the basic base unit onto the right-hand side screw.
(c) Place the left-hand side pear-shaped hole of the basic base unit onto the left hand side screw.
(d) Fit the fixing screws into the fixing screw holes in the basic base unit bottom and re-tighten all the fixing
screws.
(Note) Install the basic base unit to a panel, with no module installed in the right slot.
Remove the basic base unit after unloading the module from the right-end slot.
IB-1501452-C 60