C80 Series Connection and Setup Manual
5 Installation
5.1.3 Module Installation and Removal
This section explains how to install and remove a power supply module, PLC CPU module, CNC CPU module, input/
output module and intelligent function module or another module to and from the base unit.
[Installation]
(1) When a cap is attached to the module connector of the base unit, remove it.
(2) Place the concave part (a) of a module onto the guide (b) of the base unit.
(3) Push in the module until the module fixing hook (c) snaps into place.
Check that the module fixing hook (c) hangs the base unit and the module is mounted on the base unit
securely.
(4) Secure the module to the base unit using screws.
(Note) Be sure to fix all the modules with screws to prevent them from dropping.
The fixing screws (M3 x 12) are to be prepared by user.
(a)
(b)
(c)
63
IB-1501452-C