1. Manual valve lever shaft
2. Manual valve lever
UNIT ASSEMBLY
1) Apply lithium grease to new oil seal lip section.
2) Install new oil seal to transmission case.
3) Insert manual valve lever shaft to transmission case.
4) Install new spacer and manual valve lever to manual valve lever
shaft.
5) Install new slotted spring pin.
3. Spacer
4. Slotted spring pin
6) Rotate new spacer approximately 180 degrees.
7) Stake small hole of new spacer.
8) Press counter drive gear, using special tools.
Special Tool
(A): 09924-74510
(B): 09926-68310
1. Counter drive gear
9) Install snap ring to angular ball bearing.
1. Snap ring
AUTOMATIC TRANSMISSION 7B1-145