Suzuki SY413 Service Manual page 1987

7B-48 AUTOMATIC TRANSMISSION (3 A/T)
1. Oil level gauge
2. FULL HOT mark
3. LOW HOT mark
4. FULL COLD mark
5. LOW COLD mark
1. Oil inlet hose 2. Oil outlet hose
COLD Level Check at Room Temperature of About 25_C
(77_F)
If transmission was overhauled or fluid was drained for oil pan (and
or valve body) service, refill fluid after assembling and check its lev-
el according to following procedure.
1) Place vehicle on level surface.
2) Apply parking brake and block vehicle wheels.
3) With selector lever in P position, start engine and run it at idle
for 5 minutes. Do not race engine.
4) Move selector lever through each range and put it in P position
again.
5) With engine running at idle, check fluid level on oil level gauge.
Fluid level should be between FULL COLD and LOW COLD
marks on oil level gauge.
6) If level is below LOW COLD mark, add fluid to bring level be-
tween LOW COLD and FULL COLD marks. Use DEXRON
)
IIE, DEXRON -III or equivalent automatic transmission fluid.
Do not overfill.
The above COLD level check is strictly temporary. Therefore, as
a final check perform HOT level check. (Refer to "HOT level check
at normal operating temperature" as described previously.)
OIL COOLER HOSES
Rubber hoses for oil cooler should replaced every 3 years or
60,000 km (36,000 miles), when replacing it, be sure to note the fol-
lowing.
D Replace clamps at the same time.
D Check for fluid leakage after replacing.
D Confirm fluid level at normal operating temperature.
)
-