Suzuki SY413 Service Manual page 1899

7A2-8 MANUAL TRANSMISSION
PRECAUTION IN SERVICING (FULL-TIME 4WD)
When performing any of the following types of work, it is necessary to make the vehicle as front wheel drive by
cutting transmission of driving force to the rear wheels.
Testing following items
D Speedometer
D Chassis dynamo
D Brake
D Wheel balance
(on-vehicle type)
1. Transfer lock bolt
2. Shift fork shaft
ON-VEHICLE SERVICE
Towing vehicle with
front or rear wheels
lifted up
SWITCHING FROM 4WD TO 2WD
Set 4WD/2WD selector lever located at lower side of transfer driv-
en case to 2WD.
1) Loosen transfer lock bolt.
2) Push in shift fork shaft fully.
3) With shift fork shaft pushed in, tighten transfer lock bolt.
Tightening Torque
(a): 19 N·m (1.9 kg-m, 14.0 lb-ft)
NOTE:
D If shift fork shaft is hard to move, try to move it while turn-
ing it to the right and left little by little. Do the same when
setting back to 4WD after servicing vehicle.
D Upon completion of servicing, always set shift fork shaft
back to 4WD.
Driving front wheels
which are jacked up