Suzuki SY413 Service Manual page 1581

(A)
(B)
1. Ball stud bolt
2. Knuckle
3 Ball stud
4. Suspension arm
5. Rear bracket bolt
6. Rear bracket nut
7. Rear bracket
8. Rear bushing
9. Front bushing
10. Front bushing bolt
INSTALLATION
1) Install front bushing.
Before installing bushing, apply soap water on its circumfer-
ence to facilitate installation
Install bushing in such direction shown in figure.
1. Press
2. Front bushing
3. Suspension arm
2) Install rear bushing to suspension arm as follows. First, push in
rear bushing in such direction and angle as shown in figure (A)
and drive it into such position as shown in figure (B).
1. Rear bushing
2. Upper side
3. Body center side
4. Suspension arm
3) Attach suspension arm to suspension frame with rear bracket,
bolts and nut and hand-tighten bolts and nut.
4) Install ball stud to knuckle.
Align ball stud groove with knuckle bolt hole as shown in figure.
Then install ball stud bolt from the direction as shown.
5) Install stabilizer cushion, washer and link nut.
6) Tighten all bolts and nuts in figure to each specified torque. Re-
fer to "TORQUE SPECIFICATIONS" in this Section.
7) Install wheels and lower hoist
8) Confirm front end (wheel) alignment referring to Section 3A.
FRONT SUSPENSION 3D-13