Suzuki SY413 Service Manual page 1564

1. Lower joint
2. Upper joint of steering column
1. Interlock cable
2. Screw (If equipped)
1. Steering joint lower cover
2. Steering shaft upper joint bolt
1. Steering joint lower cover
2. Steering shaft upper joint bolt
3. Steering joint upper cover
AIR BAG STEERING WHEEL AND COLUMN 3C1-17
INSTALLATION
1) Align flat part "A" of lower joint shaft with bolt hole "B" of upper
side joint of steering column as shown. Then insert upper side
joint of steering column into lower joint shaft.
2) If equipped with shift (key) interlock cable, connect shift (key)
interlock cable to ignition switch with ignition switch turned at
"ACC" position. And then turn ignition switch to "LOCK" posi-
tion.
3) Tighten its cable screw.
4) Install steering column assembly to lower and upper brackets.
Torque steering column upper nuts first and then lower nuts to
specifications as given below.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
(b): 14 N·m (1.4 kg-m, 10.5 lb-ft)
5) Install bolt to steering shaft upper joint and tighten it to specified
torque.
NOTE:
After tightening column nuts, bolt to steering shaft upper
joint should be tightened.
Tightening Torque
(c): 25 N·m (2.5 kg-m, 18.0 lb-ft)
6) Install steering joint upper cover.