Suzuki SY413 Service Manual page 1554

1. Steering wheel side caps
2. Connector
1. Horn connectors 2. Projection of cap
AIR BAG STEERING WHEEL AND COLUMN 3C1-7
DRIVER AIR BAG (INFLATOR) MODULE
WARNING:
When handling an air bag (inflator) module, be sure to
read "HANDLING PRECAUTIONS" given earlier in this
section and observe each instruction. Failure to follow
them could cause a damage to the air bag (inflator) mod-
ule or result in personal injury.
REMOVAL
1) Disconnect negative battery cable at battery terminal.
2) Disable air bag system. Refer to "Disabling Air Bag System" un-
der "Service Precautions" earlier in this section.
3) Remove steering wheel side cap of right side and disconnect
horn connectors.
4) Remove air bag (inflator) module bolts (2 pcs).
Special Tool
(A): 09944-18230
5) Remove air bag (inflator) module from steering wheel.
INSPECTION
WARNING:
Never disassemble air bag (inflator) module or measure
its resistance. Otherwise, personal injury may result.
CAUTION:
If air bag (inflator) module was dropped from a height of
91.4 cm (3 ft) or more, it should be replaced.