Suzuki SY413 Service Manual page 1781

Front
Rear
1. Air bleeder plug
2. Weight
FLUID PRESSURE TEST
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
D Fuel tank is filled with fuel fully.
D Vehicle is equipped with spare tire, tools, jack and jack handle.
1) Place vehicle on level floor and set 200 kg (442 lbs) weight slow-
ly on axle housing center.
2) Install special tool to front and rear brake.
NOTE:
Pressure gauge should be connected to breather of front
(left side brake) and rear (right side brake).
After testing front left side and rear right side, test front
right side and rear left side in the same way.
Special Tool
Front brake
(A): 09956-02310
(B): 09952-36320
(C): 09360-10026 (Union bolt as spare part)
(D): 09161-10009 (Washer as spare part)
Rear brake
(A): 09956-02310
(E): 09952-36310
(F): 55473-82030 (Air bleeder plug as a spare part)
NOTE:
Special tool (B) or (E) is used instead of thread diameter 10
mm attachment of special tool (A).
So remove the attachment from (A) and install (B) or (E) as
shown.
3) Depress brake pedal gradually till fluid pressure of front brake
becomes as specified below and check corresponding pres-
sure of rear brake then. It should be within specification given
below.
Front brake
3 Door
4 Door 4 Door
5,000 kPa
2
50 kg / cm
711 psi
WAGON WAGON
BRAKES 5-87
Rear brake
3,200 – 3,600 kPa
32 – 36 kg / cm
455 – 512 psi
3,500 – 3,900 kPa
1.3 , 1.6 2WD 35 – 39 kg / cm
498 – 555 psi
3,900 – 4,300 kPa
1.6 4WD, 1.8 39 – 43 kg / cm
555 – 611 psi
4,300 – 4,700 kPa
1.3 , 1.6 43 – 47 kg / cm
611 – 668 psi
4,800 – 5,200 kPa
1.8 48 – 52 kg / cm
683 – 739 psi
2
2
2
2
2