Suzuki SY413 Service Manual page 2244

1. Special tool
(Joint pipe 09923-46020) or the like
2. No.1 bush
INSPECTION
1) Check clutch release bearing for smooth rotation.
2) Inspect smoothness of release bearing retaining portion of
transmission case and correct or replace right case as neces-
sary.
CAUTION:
Do not wash release bearing. Washing may cause
grease leakage and consequential bearing damage.
INSTALLATION
1) Drive in a new No. 1 bush by using adequate drive handle and
hammer and then apply grease to bush inside.
Special Tool
(A): 09943-88211
(B): 09923-46020 or the like
"A": GREASE 99000-25010 (SUZUKI SUPER GREASE A)
2) Install release shaft with return spring applied to it.
3) Apply grease to No.2 bush inside and press-fit it by using the
same special tool as in removal.
"A": GREASE 99000-25010 (SUZUKI SUPER GREASE A)
Special Tool
(A): 09922-46010
4) Coat grease to shaft seal and then install it till it is flush with case
surface. Use special tool for this installation and face seal lip
downward (inside).
"A": GREASE 99000-25010 (SUZUKI SUPER GREASE A)
Special Tool
(B): 09925-98221
5) Caulk seal at A by using caulking tool and hammer.
1. No.2 bush
2. Shaft seal
3. Release shaft
4. Caulking
CLUTCH (HYDRAULIC TYPE) 7C1-19