Suzuki SY413 Service Manual page 2005

7B-66 AUTOMATIC TRANSMISSION (3 A/T)
1. Oil pressure control cable
2. Throttle valve cam
1. Accumulator piston
7) Remove 2 oil tubes from lower valve body.
Remove them by pulling up tube end with a screwdriver.
8) Disconnect oil pressure control cable from throttle valve cam
and then remove cable.
9) Remove oil strainer and lower valve body.
For removal of lower valve body, remove 11 bolts as shown.
CAUTION:
Be careful not to let manual valve fall off when re-
moving valve body assembly.
1. Manual valve
2. Valve body bolt
10) Remove second brake accumulator upper spring and remove
accumulator pistons and springs.
Position a rag on pistons to catch each piston.
To remove pistons, force low-pressure compressed air (1 kg/
2
cm
piston into the rag.
NOTE:
Do not push accumulator pistons with fingers or anything
before removing them. Pushing them may cause com-
pressed fluid in accumulator to spew out of hole at face
and clothes
, 15 psi, 100 kPa, max) into hole as shown, and pop each