Suzuki SY413 Service Manual page 2202

1. Planetary carrier
2. Sun gear
1. Vernier
2. Straightedge
3. Forward clutch drum
32) Temporarily tighten bolts of oil pump body.
1. Oil pump body
33) Temporarily tighten transmission housing to transmission
34) Stand transmission up (ie: transmission housing facing down-
35) Install front and rear planetary carrier while rotating counter-
36) Install sun gear with needle roller bearing.
37) Coat race with grease.
3. Needle roller bearing
38) Install race to planetary carrier.
4. Race
39) Install overdrive/coast clutch while rotating counterclockwise
40) Install forward clutch while rotating.
1. Overdrive/coast clutch
41) Check for correct installation of each component parts as fol-
case with 5 – 6 bolts.
ward).
clockwise and clockwise.
Bearing race dimension
Outside diameter : Approximately 32.2 mm (1.27 in.)
Inside diameter : Approximately 18.9 mm (0.74 in.)
Thickness : Approximately 2.6 mm (0.10 in.)
Grease: 99000-25030 (SUZUKI SUPER GREASE C)
and clockwise.
NOTE:
Check to make sure that overdrive/coast clutch locks
when turned counterclockwise (1) and moves freely when
turned clockwise (2).
lows.
Measure the distance "a" by using vernier and straightedge. If
out of specification, remove forward clutch, overdrive/coast
clutch, front and rear planetary carrier and reinstall them prop-
erly.
Distance "a": 46.94 – 47.81 mm (1.848 – 1.882 in.)
AUTOMATIC TRANSMISSION 7B1-149