Suzuki SY413 Service Manual page 1926

1. Differential side R bearing
2. Differential case
1. Circlip 2. Speedometer drive gear
1. Differential side L bearing
2. Differential case
DIFFERENTIAL ASSEMBLY
Disassembly
1) Using special tool, remove R bearing.
Special Tool
(A): 09913-61510
(B): 09925-88210
NOTE:
Change removed bearing to new one.
2) Remove L bearing by using puller while supporting its center
shaft as described above.
3) Remove circlip.
4) Take out speedometer drive gear.
5) Support differential case with soft jawed vise and remove final
gear bolts then take out final gear and output bevel gear.
6) For disassembly procedure, refer to Step 5) of same item in
Section 7A.
Adjustment and Reassembly
Judging from abnormality noted before disassembly and what is
found through visual check of component parts after disassembly,
prepare replacing parts and proceed to reassembly. Make sure
that all parts are clean.
1) For adjustment and reassembly procedure, refer to Steps 1)
and 2) of same item in Section 7A.
2) Drive in spring pin from right side till it is flush with differential
case surface.
3) Press-fit L bearing by using special tool and copper hammer.
Special Tool
(A): 09951-76010
MANUAL TRANSMISSION 7A2-35