Suzuki SY413 Service Manual page 1485

3B-4 MANUAL RACK AND PINION
1. Steering shaft upper joint bolt
2. Steering shaft lower joint bolt
REMOVE AND INSTALL MANUAL RACK AND
PINION ASSEMBLY (STEERING GEAR
CASE)
REMOVAL
1) Slide driver's seat as far back as possible.
2) Pull off front part of floor mat on driver's side and remove steer-
3) Loosen steering shaft upper joint bolt but don't remove, and re-
4) With front wheels in straight-ahead position, disconnect lower
5) Hoist vehicle and remove both wheels.
6) Remove split pins and tie rod castle nuts from both knuckles.
1. Steering knuckle
2. Castle nut
3. Split pin
7) Disconnect both tie rod ends from knuckles, using special tool
1. Steering knuckle
2. Tie rod end
8) Remove steering gear case mount bolts, gear case brackets
1. Gear case mount bolt
2. Steering gear case
ing shaft joint covers.
move lower joint bolt.
CAUTION:
For vehicle equipped with air bag system, be sure to
set front wheels in straight direction and remove igni-
tion key from key cylinder before following steps,
otherwise contact coil of air bag system may get dam-
aged.
joint from pinion.
(A).
Special Tool
(A): 09913-65210
and then gear case.