Suzuki SY413 Service Manual page 1644

1. Brake light switch
1. "SPORT" indicator light
1. Absorber adjusting actuator (front)
2. Absorber adjusting actuator (rear)
DIAGNOSIS SWITCH TERMINAL
1. Diagnosis
connector 1
The diagnosis switch terminal is included in the diagnosis connec-
2. Diagnosis
connector 2
tor 2 in the relay box. When diagnosis switch terminal is grounded,
3. Relay box
4. Diagnosis
a diagnosis signal is fed to suspension control module which then
switch
outputs diagnostic trouble code.
terminal
5. Ground
terminal
BRAKE LIGHT SWITCH
The same switch is used as the brake light switch.
Receiving this signal, suspension control module detects that ve-
hicle is in braking condition.
"SPORT" INDICATOR LIGHT
The "SPORT" indicator light is located in the combination meter.
This light turns ON when mode selector switch is in "SPORT"
mode, flashes at failure in system and flashes to output diagnostic
trouble code when diagnosis switch terminal is grounded.
ABSORBER ADJUSTING ACTUATOR
The four absorber adjusting actuators are installed on top of each
suspension strut.
These actuators consist of stepper motor and adjust each suspen-
sion absorber damping force according to the signal from suspen-
sion control module.
SUSPENSION CONTROL SYSTEM 3G-7