Suzuki SY413 Service Manual page 1989

7B-50 AUTOMATIC TRANSMISSION (3 A/T)
1. Oil pan
1. Oil strainer
1. Coupler
2. 2nd brake solenoid valve
3. Direct clutch solenoid valve
5) Tighten oil pan bolts to the following torque one after another di-
agonally.
CAUTION:
Over tightening of bolts may cause fluid leakage.
Tightening Torque
(a): 5 N·m (0.5 kg-m, 4.0 lb-ft)
(b): 21 N·m (2.1 kg-m, 15.0 lb-ft)
6) Upon completion of installation, warm up transmission and
check for fluid level and leakage. (Refer to "Fluid level".)
OIL STRAINER
1) Drain transmission fluid.
2) Remove oil pan.
3) Remove oil strainer.
4) Clean oil strainer.
5) Install oil strainer to lower valve body.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
6) Reinstall oil pan and refill transmission fluid.
7) Upon completion of installation, warm up transmission and
check for fluid level and leakage. (Refer to "Fluid level".)
SHIFT SOLENOID VALVES
REMOVAL
1) Drain transmission fluid and remove oil pan.
2) Disconnect couplers from direct clutch and 2nd brake solenoid
valves, and then remove solenoid valves.
3) Remove solenoid valve wire harness with grommet from upper
side.