Suzuki SY413 Service Manual page 1904

1. Shift & select control
cables
1. Instrument panel
2. Heater control panel
3. Shift cable adjusting nut
4. Control lever knob
5. Lock nut
1. Select cable adjusting nut
2. Lock nut
REMOVAL
1) Remove parking brake lower cover and console box.
2) Remove E-rings and clips from shift & select control cables.
3) Remove gear shift lever assembly.
2. E-rings
3. Clip
INSTALLATION
Reverse removal procedure for installation and note as follows.
D Adjustment of shift cable.
With shift lever in NEUTRAL position, adjust shift cable adjusting
nut so that distance "a" between edge of instrument panel and
center of shift knob measured as shown.
NOTE:
D After shift cable adjustment, tighten lock nut securely.
Tightening Torque
(a): 6 N·m (0.6 kg-m, 4.5 lb-ft)
D Make sure that boots are installed correctly.
Distance "a": 137 mm (5.4 in.)
D Adjustment of select cable.
With shift lever in NEUTRAL position, adjust select cable adjust-
ing nut so that front side end surface
side line of rib
NOTE:
After select cable adjustment, tighten lock nut securely.
Tightening Torque
3. Rib
(a): 6 N·m (0.6 kg-m, 4.5 lb-ft)
4. Select arm
MANUAL TRANSMISSION 7A2-13
of select arm and rear
are aligned.