Suzuki SY413 Service Manual page 1624

3E1-4 REAR SUSPENSION (4WD VEHICLE)
1. Match marks
1. Clamps for ABS
wheel speed sensor
(if equipped)
9) To facilitate reinstallation, put match marks on No.2 propeller
shaft flange and differential flange.
Disconnect No.2 propeller shaft from differential.
10) Remove differential, differential mounting and mounting
bracket from suspension frame.
11) Remove suspension frame from vehicle body.
INSTALLATION
1) Install suspension frame to vehicle body and tighten suspen-
sion frame bolt to specified torque.
Tightening Torque
(a): 90 N·m (9.0 kg-m, 65.0 Ib-ft)
2) Install differential mounting, mounting bracket and differential
to suspension frame.
Tighten each bolt to specified torque referring to SECTION 7F.
3) Connect No.2 propeller shaft to differential aligning match
marks on flanges. Tighten bolts and nuts to specified torque
referring to SECTION 4B.
4) Install drive shafts (right and left) referring to SECTION 4C.
5) Install control rods referring to CONTROL ROD INSTALLA-
TION of SECTION 3E.
6) For vehicle equipped with ABS, attach ABS wheel speed sen-
sor connector and harness to suspension frame.
7) Fill differential oil, referring to SECTION 7F.
8) Install wheels and tighten wheel nuts to specified torque.
9) Perform Step 4) to 6) CONTROL ROD INSTALLATION of
SECTION 3E.