Suzuki SY413 Service Manual page 1559

3C1-12 AIR BAG STEERING WHEEL AND COLUMN
1. Junction/fuse block
1. Contact coil and combination switch assembly
1. Contact coil and combination switch assembly
2. To horn
3. Connector to driver air bag (inflator) module
4. Connector to air bag wire harness
1. Seal If equipped, remove lock pin after installing
2. Lock pin contact coil and combination switch assembly.
10) Disconnect three connectors for contact coil and combination
switch wire harness from junction/fuse block.
11) Remove contact coil and combination switch assembly from
steering column.
INSPECTION
Check contact coil and combination switch wire harness for any
signs of scorching, melting or other damage. If it is damaged, re-
place.
INSTALLATION
1) Check to make sure that vehicle's front tires are set at straight-
ahead position and then ignition switch is at "LOCK" position.
2) Install contact coil and combination switch assembly to steering
column.
NOTE:
New contact coil and combination switch assembly is sup-
plied with contact coil set and held at its center position
with a lock pin and seal. Remove this lock pin after instal-
ling contact coil and combination switch assembly to
steering column.