Suzuki SY413 Service Manual page 1523

3B1-26 POWER STEERING (P/S) SYSTEM
1. Pipe bracket bolt
2. High pressure hose
1. Pump mount bolt
2. Pump pulley
3. Generator
4. Crankshaft pulley
4) Disconnect high pressure hose and suction hose from power steer-
3. Suction hose
5) Remove pipe bracket bolts.
4. Throttle body
5. Power steering pump
6) Remove pump mount bolts and detach power steering pump from
INSTALLATION
Reverse removal procedure.
NOTE:
D Fill specified power steering fluid after installation and bleed
D For tightening torques, refer to structural diagram on previous
D [1.3 L and 1.6 L engine models]
D [1.8 engine model]
D Bleed air from P/S system by referring to AIR BLEEDING PRO-
ing pump. As fluid flows out of disconnected joints, put a container
under joints or a plug to hose.
CAUTION:
When disconnecting, take care not to cause damage to
generator.
bracket, while detaching, do not forget to disconnect lead wire from
the pump.
NOTE:
Plug each port of removed pump to prevent dust or any other
foreign matter from entering.
air without failure.
page.
Adjust power steering belt tension, refer to POWER STEERING
BELT (1.3 L AND 1.6 L ENGINE MODELS).
Adjust generator belt tension, refer to GENERATOR BELT (1.8
L ENGINE MODEL).
CEDURE in this section.