Suzuki SY413 Service Manual page 2006

1. Piston rod
2. Oil hole (Blow air )
A: Stroke measuring mark
B: Identification mark
1. 17 mm socket 3. Piston cover
(Install with bolt) 4. Second brake piston
2. Snap ring
1. Solenoid wire
hold plate nut
2. Solenoid wire
harness clamp
11) Remove second brake band cover and gasket.
12) After removing second brake band cover, check second brake
piston stroke as follows.
i) Scribe mark on piston rod as shown.
ii) Blow air into oil hole and measure rod stroke.
iii) If stroke is out of specification, replace piston rod with the
one of different length or replace second brake band.
2nd brake piston rod of 2 different lengths are available as
spare parts.
Piston rod length
A il bl
Available
121.3 mm (4.77 in.)
piston rod iston rod
122.7 mm (4.83 in.)
Piston rod stroke "a": 1.5 – 3.0 mm (0.06 – 0.11 in.)
13) Remove second brake piston.
i) Install 17 mm socket with 8 mm bolt.
ii) Apply valve lifter as illustrated and push in piston cover.
Special Tool
(A): 09916-14510
iii) Remove snap ring by using screwdriver(s) or the like.
iv) Remove tools and take out 2nd brake piston cover and pis-
ton. Tap cover head lightly to pull out cover.
14) Remove solenoid wire harness.
i) Remove wire hold plate securing nut.
ii) Remove 2 wire clamps on transmission and pull out sole-
noid wire.
AUTOMATIC TRANSMISSION (3 A/T) 7B-67
Identification mark
Unmarked
Marked