Suzuki SY413 Service Manual page 1612

3E-20 REAR SUSPENSION (2WD VEHICLE)
1. Brake disc dust cover
2. Control rod
1. Knuckle
2. No.1 control rod
1. Strut bracket bolt & nut
REMOVE AND INSTALL KNUCKLE
REMOVAL
1) Hoist vehicle and remove wheel hub referring to WHEEL HUB
2) If the vehicle is equipped with ABS, remove rear wheel speed
3) Remove caliper carrier from knuckle.
4) Remove brake disc dust cover.
3. Trailing rod
5) Loosen control rod outer bolts, trailing rod rear bolt and strut
6) Disconnect control rods (No.1 and No.2) from knuckle.
7) Disconnect trailing rod from knuckle.
3. No.2 control rod
4. Trailing rod
8) Remove knuckle from strut.
2. Knuckle
REMOVAL in this section.
sensor, refer to SECTION 5B of Service Manual mentioned in
FOREWORD of this manual.
bracket nuts.