Suzuki SY413 Service Manual page 1493

3B-12 MANUAL RACK AND PINION
REMOVE AND INSTALL RACK BUSHING
REMOVAL
NOTE:
When removing rack bushing, be careful not to pull out bush-
ing by holding gear case in a vise. Or housing (pipe) may come
off gear case. For this work, be sure to use the specified spe-
cial tool.
1) Remove rack from steering gear case, referring to STEERING
RACK REMOVAL of this section.
2) Remove snap ring.
1. Rack housing
2. Snap ring
3. Bushing
3) Pull out bushing from rack housing with special tool (A) as
shown.
Special Tool
(A): 09944-48210
INSTALLATION
1) Apply grease lightly to entire inner surface of bushing and con-
firm that it is free from any damage or scratch.
2) Press-fit bushing as far into rack housing as shown by using
special tool (B).
CAUTION:
Inside of bushing is coated with special coating. As it
is damageable, be sure to use special tool and special
care not to cause damage to inside of bushing
when press-fitting it.
Special Tool
(B): 09943-78210
3) Install new snap ring.
4) Follow Steps 1) to 5) in STEERING RACK INSTALLATION of
this section to complete installation.