Suzuki SY413 Service Manual page 1401

Vehicle with A/C
Vehicle with A/C and power steering
Vehicle with power steering
1. A/C compressor pulley
2. Power steering pump pulley
1. Generator pulley
2. Water pump pulley
MAINTENANCE SERVICE
ENGINE
ITEM 1-1
Drive Belt Inspection and Replacement
WARNING:
Disconnect negative cable at battery before checking
and adjusting belt tension.
1.3L, 1.6L Engine
A/C Compressor and/or Power Steering Pump Drive Belt
Inspection (If equipped)
1) Detach air cleaner assembly from vehicle body and shift its
position.
2) Inspect belt for wear, deterioration and tension.
Replace or adjust, if necessary.
A/C compressor and/or power steering pump drive belt
tension "a":
7 – 9 mm (0.28 – 0.35 in.) deflection under 10 kg or 22 lb
pressure
A/C Compressor and/or Power Steering Pump Drive Belt
Replacement
1) Disconnect negative cable from battery.
2) Remove engine under cover of right side.
3) Loosen belt tension and replace belt with new one.
4) Adjust belt tension to specification referring to SECTION 1B or
SECTION 3B1.
5) Install engine under cover and connect negative cable to bat-
tery.
3. Tension pulley
4. Crankshaft pulley
Water Pump Belt Inspection
1) Remove engine under cover of right side from vehicle body.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
Replace, if necessary.
3) Check pump belt for tension and adjust it as necessary.
Water pump belt tension "a":
6 – 8 mm (0.24 – 0.32 in.) deflection under 10 kg or 22 lb
pressure
3. Crankshaft pulley
MAINTENANCE AND LUBRICATION 0B-5