Table of Contents
Advertisement
Indicator
Description
readings exceed the maximum counts or are less than the
minimum counts
Display Applications
A number represents the Display Group number currently
1
displayed.
The displayed item's value is above the Data High Limit value
↑
on the display Item Setup screen.
The displayed item's value is below the Data Low Limit value
↓
specified on the display Item Setup screen.
IMPORTANT NOTE: The status and alarm code area is
customizable. Each of the 8 annunciator display fields, shown in
Figure 13-1: XSeriesG5
display any of the available indicators in any of the 8 locations.
Failure to start
The LCD displays the startup sequence after power up. See details in
section
6.1 Super capacitor charging at boot
cycling though the pre-programmed items. If it fails to cycle and locks up,
follow the procedure below.
IMPORTANT NOTE: Display time for screens 1 through 4 will vary. If
the startup cycle stops, record the details on the screen. Provide the
screen details to technical support to help them resolve the issue.
The screen has locked up
Follow this procedure to correct the problem:
1.
Attach the lithium battery to the board.
2.
Perform a warm boot:
Locate RESET (XFC S2 and XRC S6) on the electronic board,
a.
press and hold for 10 seconds.
b.
View the screen during startup to verify that the unit warm-
starts and begins cycling.
i.
If the display moves through the startup screens and begins
cycling correctly, the reset was successful and it is not
necessary to continue this procedure.
ii.
If the display does not begin cycling correctly or locks up on
one of the startup screens, continue to step 3.
3.
Perform a cold boot:
7 4 | XSE RI ES G5 STA RT UP GUI DE | 21 0 60 0 1MNAA
annunciators, may be programmed to
time. The display should begin
Advertisement
Table of Contents
