1.
Connect the battery to the BATT terminals on the XFC (J1 as shown
below) or XRC (J16). Observe the polarity (+ and -).
Figure 6-2: XFC BATT connector
2.
Confirm that the battery is supplying power to the XFC or XRC by
observing the power-on sequence information scrolling on the LCD
(see details in Section
3.
If the power-on sequence fails to initiate or complete, press the
reset button (shown below).
Figure 6-3: Reset button and coldboot button
Connect the charger
NOTICE – Equipment damage. Always connect the battery to the
BATT port before connecting the solar panel or alternate charger
cable to the XFC or XRC.
Connect the solar panel charger:
1.
Reinsert the CHRG connector wired to the charger cable to the
CHRG terminal on the XFC (J5 shown below) or XRC (J17).
6.1 Super capacitor charging at boot
2 1 0 60 01M NAA | XSER IE S G5 S TART UP G UI DE | 4 3
time).