Table of Contents
Advertisement
Figure 10-6: Enable and configure Ethernet communication
Click Send. A message displays to confirm the change.
5.
Click Yes to confirm.
6.
Click Re-read to refresh the screen and verify that the Ethernet
7.
Status displays Ready.
8.
Verify that the saved IP configuration is correct.
a.
If DHCP is enabled, the IP parameters automatically configure.
b.
If the IP parameters are not displayed, the device did not
obtain the parameters from the DHCP server.
i.
ii.
9.
Ping the IP address of the device from the corporate network or local
switch and verify that the device replies.
IMPORTANT NOTE: To restart or reinitialize the Ethernet
interface, click Restart on the Ethernet screen. It is no longer
necessary to restart the device.
Enable Wi-Fi
The XFC and XRC support Wi-Fi Access Point (AP) functionality. This allows
wireless local access for clients with Wi-Fi wireless capabilities. When
Ensure that the connection to the corporate network is
active and verify that the DHCP server is running and
available.
If unable to connect to the DHCP server, contact the IT
administrator.
2 1 0 60 01M NAA | XSER IE S G5 S TART UP G UI DE | 6 1
Advertisement
Table of Contents
