Table of Contents
Advertisement
Figure 6-4: XFC charger connection
Power with external power supply
An external power supply can power the XFC and XRC.
The XFC and XRC are 12 Vdc nominal powered devices. The voltage range
from an external supply must be 9 Vdc to 15.5 Vdc.
NOTICE – Equipment damage: A battery cannot be used when
the XFC or XRC is in external power mode.
Wire or connect an external power supply to the XFC or XRC:
1.
Review the manufacturer's instruction supplied with the external
power supply.
2.
Wire or connect the external power supply cable to the BATT
connector as shown below. Observe the polarity (+ and -).
Figure 6-5: Connect the external power supply
3.
Confirm that the XFC or XRC is receiving power by observing the
power-on sequence information scrolling on the LCD (see details in
section
6.1 Super capacitor charging at boot
4.
If the power-on sequence fails to initiate or complete, see section
13.2 Failure to start.
4 4 | XSE RI ES G5 STA RT UP GUI DE | 21 0 60 0 1MNAA
time).
Advertisement
Table of Contents
