Table of Contents
Advertisement
—
Safety
Read these instructions carefully prior to installation and commissioning. The instructions do not
contain all the details for all types of product and, therefore, do not list all assembly, operating, or
maintenance scenarios. For further information or if specific problems arise which are not addressed in
the instructions, ask the manufacturer. The content of these instructions is neither part of nor
provided for changing a previous or existing agreement, promise, or legal relationship. All ABB
obligations result from the respective sales contract, which also contains the full and solely valid
warranty clauses. These are neither limited nor extended by the content of these instructions.
Observe warning signs on packaging and on the device, etc.
Only qualified and authorized specialists are to be employed for the assembly, electrical connection,
commissioning, and maintenance of the device. Qualifications include:
Training or instruction and/or authorization to operate and maintain devices or systems
according to safety engineering standards for electrical circuits, high pressures, and
aggressive media
Training or instruction in accordance with safety engineering standards regarding maintenance
and use of adequate safety systems
!
WARNING – Bodily injury: According to EN 60 900, only sufficiently insulated tools may
be used for the electrical connection.
Compliance is required for the applicable standards and safety regulations concerning the construction
and operation of electrical installations:
The regulation on technical working materials (safety guidelines for tools)
The regulations and recommendations relating to explosion protection, if transmitters with
explosion protection are to be installed
The recommendations for safe working in the case of installation in an SIL loop
The device can be operated at high levels of pressure and with aggressive media. Serious injury
and/or considerable material damage can be caused if this device is handled incorrectly. Ensure
compliance with the regulations applicable in the country of use when working with the device.
The following conventions are used throughout this document to bring attention to important
information:
Although "WARNING" hazards are related to personal injury and "NOTICE" hazards are associated with
equipment or property damage, it must be understood that under certain operating conditions,
operating damaged equipment can result in degraded system / process performance leading to
serious or life-threatening injuries. Therefore, compliance with all "WARNING" or "NOTICE" hazards is
required at all times.
!
DANGER – Serious damage to health / risk to life. These symbols and the signal word
"DANGER", indicate imminent danger or electrical hazard. Failure to observe this safety
information will result in death or severe injury. The text may state the hazard, how to avoid
the hazard, and the result if not followed. The lightning bolt is for electrical danger; the
exclamation point is for general dangers.
DANGER – Serious damage to health / risk to life. This symbol, and the signal word
"DANGER", indicate imminent danger or explosive hazard. Failure to observe this safety
information will result in death or severe injury. The text may state the hazard, how to avoid
the hazard, and the result if not followed.
!
WARNING – Bodily injury. These symbols and the signal word "WARNING", indicate a
potentially dangerous situation. Failure to observe this safety information could result in death
or severe injury. The text may state the hazard, how to avoid the hazard, and the result if not
followed. The bolt is for electrical warnings; the exclamation point is for general warnings.
2 1 0 60 26M NAA | XSER IE S
G 5
| 1 1
Advertisement
Table of Contents
