Start PCCU and use Entry mode to connect to the device.
Select Communications> Network.
Select the SSH/SFTP service checkbox.
Figure 9-19: Enable the SSH/SFTP service
Click Send.
Select Ethernet to enable, verify or configure valid IP parameters. The figure below shows
an example of a valid IP configuration to access the device over a network. If using a local
point-to-point to connection, configure accordingly. Click Help for additional details.
Figure 9-20: Enable and configure Ethernet (Network Adapter)
Click Send to save any changes.
Connect the XSeries
connection is local). Keep your serial or USB connection open.
Launch the FileZilla application.
Click Open the Site Manager. The Site Manager window displays
Configure the General tab parameters as follows:
9 4 | XSE RI ES G5 | 2 10 6 02 6MNAA
G5
device to the network or to the laptop or PC (if the Ethernet
(Figure
9-21).