Table of Contents
Advertisement
PI
Debounce
6.1.3
Digital outputs (DO)
Digital outputs (DO) on XSeries
IMPORTANT NOTE: Analog inputs must be compatible with the external devices they connect
to. Review the external device's specifications to ensure that the AI can support the device's
output signal type and range.
6.2.1
XFC
G5
The XFC
G5
has two onboard analog inputs. Each AI consists of an input signal pin and an input ground
pin.
Determine which AI to use and refer to the pinout table for wiring.
IMPORTANT NOTE: The XFC
20 mA) inputs, add a 250-ohm resistor across the + and – terminals.
inputs
(AI),
for additional information on input mode and range.
Figure 6-1: XFC
G5
AI terminals
Table 6-4: XFC
G5
AI Pinouts
Input
Pin
AI-1
1
2
AI-2
3
6.2.2
XRC
G5
The XRC
G5
has five onboard analog inputs. Determine which AI to use and refer to the pinout table for
wiring.
Figure 6-2
shows the XRC
jumpers to set the analog input for the type of input signal expected (voltage or current). Follow the
legend to set the correct AI to the correct mode. By default, all analog inputs are set for voltage
inputs (0 -10 V, pins 2 and 3 are jumpered). See
on input mode and range.
XFC
G5
Yes, software selectable
from user interface (PCCU): Debounce
can be enabled/disabled on each PI.
G5
devices are used to control external equipment.
AI
G5
AIs support voltage inputs by default. To support current (4 –
Description
(+) Input signal
(-) Input ground
(+) Input signal
(-) Input ground
AI
G5
analog input terminals and the input mode selector jumpers. Use these
XRC
G5
Yes, hardware selectable
with onboard pins (J5, J9, J11, J12):
Debounce on (default): Jumper pins
2-3
Debounce off: Jumper pins 1 and 2
6.1.1, Analog inputs (AI)
See section
6.1.1 Analog
for additional information
2 1 0 60 26M NAA | XSER IE S
G 5
| 5 1
Advertisement
Table of Contents
