Table of Contents
Advertisement
—
6
Wire I/Os
Wire the XFC
G5
or XRC
general description of the XSeries
about the TFIO module support. TFIO modules are optional expansion interfaces used to provide
additional I/O points, when the ones provided onboard are not sufficient.
IMPORTANT NOTE: Refer to the XFC
external devices. See
NOTICE – Equipment damage. An external device can be powered from VBAT or SW VBAT pins
on the COMM terminals.
The output voltage at these pins is dependent upon the external power supply connected to the
CHRG connector (J5 on XFC
to 15.5 Vdc The XFC
Before connecting an external device to VBAT or SW BAT, ensure that the device is compatible
with this voltage range. Connecting an incompatible device may result in damage to the device.
Inputs provide the ability to read and monitor signals transmitted from external devices. Outputs
provide the ability to send signals to control external devices.
The following table provides the I/O general description. For detailed specifications visit
www.abb.com/upstream
IMPORTANT NOTE: Onboard input/output information is also available in the PCCU online help
topics. Click Help from any of the I/O and calibration screens.
Table 6-1: I/O general description
Board
ID: I/O
J8: 2 AIs
XFC
G5
J6: 2 DI/PIs, 2 DOs
J7: RTD input
J23: 5 AIs
XRC
G5
J8-A: 2 DI/PIs, 2 DOs
J8-B: 2 DI/PIs, 2 DOs
G5
I/O ports to monitor or control external devices. This section includes a
G5
I/Os, detailed pinouts for each I/O type, and general information
Additional
information.
G5
, J17 on XRC
G5
and XRC
G5
are 12 Vdc nominal powered devices.
to review product datasheets.
Connector type
Removable terminal connectors:
J8: 4-POS, J7: 5-POS J6: 8-POS
Screw termination.
Wire gauge 12 AWG to 22 AWG
Removable terminal connectors:
J23: 10-POS, J8-A/J8-B: 9-POS
Screw termination.
Wire gauge 12 AWG to 22 AWG
G5
or XRC
G5
user drawings for I/O wiring details for specific
G5
). The voltage range at J5 or J17 can be from 9 Vdc
Use
Monitor analog input (AI) or
digital/pulse input (DI/PI)
signals received from external
equipment
Send digital output (DO)
signals to control external
equipment
Dedicated RTD (on XFC
input for temperature
measurement
Same as above (except, no
dedicated RTD on the XRC
2 1 0 60 26M NAA | XSER IE S
G5
only)
G5
)
G 5
| 4 9
Advertisement
Table of Contents
