Replacing A Camera - Huawei FusionModule1000A40 ICT Solution Maintenance Manual

FusionModule1000A40 ICT Solution
Maintenance Guide
Procedure
Step 1 Label each cable based on the corresponding ports on the smart ETH gateway.
Step 2 Disconnect cables from the smart ETH gateway.
Step 3 Remove the faulty smart ETH gateway from the guide rails of the cable trough.
Step 4 Install the spare smart ETH gateway in the original position and connect the cables.
----End
Follow-up Procedure
Dispose of the removed ETH gateway that is confirmed faulty.

4.3.6 Replacing a Camera

Prerequisites
A spare camera of the same model is available and functional.
Impact on the System
Video surveillance stops.
Preparations
Tools: Phillips screwdriver, step ladder, protective gloves
Material: spare camera
Documents: documents delivered with the camera, management system initial configuration
table
Skill requirement: weak-current engineer
Procedure
Step 1 Remove screws securing the transparent cover of the camera body using a Phillips
screwdriver.
Issue 01 (2019-03-05)
For the table, see the initial configuration parameter manual for the solution in use.
Copyright © Huawei Technologies Co., Ltd.
4 Parts Replacement
99