Removing A Camera Spd Module - Huawei FusionModule1000A40 ICT Solution Maintenance Manual

FusionModule1000A40 ICT Solution
Maintenance Guide
Step 5 Clamp the new CIM to the fastener.
Step 6 Set the DIP switch for the CIM based on the recorded information.
Step 7 Reconnect cables to the CIM based on the cable labels.
Step 8 After installing the CIM, network the CIM and BIM. For details, see the description about
power-on commissioning in the iBAT 2.0-CIM01C2 User Manual.
----End
Follow-up Procedure
Dispose of the removed CIM that is confirmed faulty.

4.3.16 Removing a Camera SPD Module

Prerequisites
A spare camera SPD module of the same model is available and functional.
Context
An SPD module consists of an SLPU and a UFLP. The SLPU is a 19-inch wide and 1 U high
box-type device. Figure 4-60 shows the SLPU, and Figure 4-61 shows the UFLP panel.
Figure 4-60 SLPU appearance
Figure 4-61 UFLP panel
FE/GE0 and FE/GE1 at the INSIDE side;
connecting to monitoring devices outside the
pre-fab. module
Impact on the System
None
Issue 01 (2019-03-05) Copyright © Huawei Technologies Co., Ltd.
FE/GE0 and FE/GE1 at the OUTSIDE side;
connecting to the LAN switch inside the
pre-fab. module
4 Parts Replacement
119