Toshiba V Series User Manual page 48

Chapter 1 Overview
1
32
LP02/LP04 Terminal Block (UT5L12)
Table 1-28 shows signal assignments on the LP02 terminal block.
Table 1-28 LP02/LP04 Terminal Block Signal Assignments
Pin No.
1 Analog Input 1
2 Analog Input 2
3 Analog Input 3
4 Analog Input 4
5 SC(Common)
6 Analog Output 1
7 SC(AI/AO Common)
8 Analog Output 2
9 SC(AI/AO Common)
10 N.C.
11 N.C.
12 N.C.
13 Digital Input 1
14 Digital Input 2
15 Digital Input 3
16 Remote/Manual DI
17 Digital Output 1
18 Digital Output 2
19 Digital Output 3
20 MV OPEN(+)
21 MV CLOSE(+)
22 DIO 0V (DI/DO Common)
23 DIO 0V(DI/DO Common)
24 DIO 24V(+) (DI/DO 24V)
Note: Leave the pins for the signal N.C. unconnected.
AI1 to AI4: Connect an analog input (1 to 5 VDC).
Connect the common (-) to SC.
AO1, AO2: Connect an analog output (1 to 5 VDC).
Connect the common (-) to SC.
MV OPEN (+): Connect an MV output (digital output) load.
Connect the common (-) to DIO OV.
MV CLOSE (+):Connect an MV output (digital output) load.
Connect the common (-) to DIO OV.
DI1 to DI3: Connect a digital input (contact).
Connect the common (-) to DIO OV.
R/M: Connect a remote manual (digital input contact).
Connect the common (-) to DIO OV.
DO1 to DO3: Connect a digital output load.
Connect DIO 24 V (+) as power for the load.
Connect the common (-) to DIO OV.
Note 1: Leave the N.C. pins unconnected.
Note 2: Pins 5, 7, and 9 on the terminal block are connected inside.
Note 3: Pins 22 and 23 on the terminal block are connected inside.
Note 4: Do not directly connect power lines to digital outputs (DO1 to DO3), MV OPEN
(+), and MV CLOSE (+). Otherwise, the internal parts will be damaged.
Signal
(AI1)
(AI2)
(AI3)
(AI4)
(AO1)
(AO2)
(DI1)
(DI2)
(DI3)
(R•M)
(DO1)
(DO2)
(DO3)
model 1000 Loop Controller L1 User's Manual - Basic Hardware