Toshiba V Series User Manual page 82

Chapter 1 Overview
1
66
(16)When the EN5 module information is successfully read from the serial
communication port, confirm that the EN5 module information can be read through
Ethernet.
First, disconnect the RS-232C cable to confirm that the information was read through
Ethernet.
From the Set Transmission Parameter window, set the parameters to confirm the
information through Ethernet.
Select Means of transmission: Ethernet. It is not necessary to set the other
parameters again because the settings read from the serial communication port will
be used.
Click the <OK> button.
Start the Configuration Editor [Hardware Configuration] for Controller A to open the
window which shows the hardware configuration registered of controller A. Then,
select [EN5 module], and execute [Edit (E)] and [Set Parameters (P)], and the
following window is displayed. Click [Tool and EN Card (B)], and the network
information stored in the Ethernet module is displayed through Ethernet.
Figure 1-40
model 1000 Loop Controller L1 User's Manual - Basic Hardware