Setting Default Gateway Ip Address; (Router Ip Address) - Toshiba V Series User Manual

1.8.7 Setting default gateway IP address (router IP address)
(1) To use a default gateway (router), set a default gateway IP address (router IP
address). Only one default gateway IP address can be set.
The default gateway can be used only if an IP address type is set from the
Engineering Tool.
The default gateway function is valid for the Ethernet basic software version V2.00 or
up for the EN5 module
(2) Register the default gateway IP address that has the same value as the network
address part (including subnet) of the IP address of the EN5 module to be registered.
(In the present case, 192.168.00**)
A setting example is shown below.
(This time 192.168.0.10)(subnet mask: 255.255.255.0)
Figure 1-43 System Configuration for Above Example of Default Gateway
An example of setting with the Engineering Tool is shown below.
Note
Multicast messages from the EN5 module will not exceed the default gateway.
6F8C1005
EN5 module
192.168.0.20
Default gateway
(route)
Personal computer, etc.
IP Address Setting
1.8 Setting Ethernet Module
192.168.0.10
xx.yy.zz.vv
1
69