Removing - Toshiba V Series User Manual

(2) Slightly lift the bottom of the terminal block unit, fit the top of the DIN rail into the DIN
rain mounting groove, slide it downward, and engage the upper end of the DIN rail
with the DIN rail.
(3) Push the bottom of the terminal block unit downward by pushing the lower tab down
toward the DIN rail using a slotted screwdriver to engage the unit and the rail.
(4) Slide the unit to the left on the DIN rail and push it to the connector or stopper of the
front unit till it is in close contact.
2.2.2

Removing

(1) Push up the stopper with a slotted screwdriver to make the terminal block unit easily
be removed.
Remove the units beginning with the rightmost one in the reverse order of mounting.
(2) Remove the terminal block unit from the DIN rail.
6F8C1005
Base unit
ベ ス ユ ニ ッ
4m m spacer
Reinforcing DIN 4mm ス ペ
補 強 曾 入 DIN レ ル
rail added
Figure 2-3 DIN Rail Support for Reinforcement
Stopper
Figure 2-4 Mounting a Terminal Block
2.2 Mounting and Removing Terminal Block Unit
Reinforcing DIN
サ
Fixed DIN rail
補 強 曾 入 DIN レ
取 付 DIN レ ル
rail added
DIN rail
(4)
(3)
ル
(1)
(2)
73
2