Optional) Installing A Pad - Huawei FusionModule1000A20 Installation Manual

FusionModule1000A20 Prefabricated All-in-One Data
Center
Installation Guide
Skill requirement: common technician
Procedure
Step 1 Attach the WiFi antenna on the ceiling.
Step 2 Connect WiFi antenna cable to the RF_1 and RF_2 ports of the WiFi converter.
Figure 6-29 Installing a WiFi antenna
----End

6.4.3 (Optional) Installing a Pad

Prerequisites
The pad to be installed has been obtained.
Context
Tool: Phillips screwdriver
Materials: pad and pad charging cable
Skill requirement: common technician
Procedure
Step 1 Adjust the feet at the bottom of the pad mounting support until they are in the same width as
the pad. Route the pad power cable through the cable hole in the pad mounting support and
then connect the cable to the pad.
Issue 02 (2020-01-15) Copyright © Huawei Technologies Co., Ltd.
6 Installing Devices Inside the Pre-fab. Module
61