Huawei E9000 Troubleshooting Manual page 25

Huawei Servers
Troubleshooting
Step 3 (Optional) Run the following command to query the IP address of the
management network port of the Ethernet switching plane:
smmget -l swi
The parameters are described as follows:
●
●
Check whether the IP address is 0.0.0.0.
●
●
Step 4 (Optional) Run the following command to set an IP address for the management
network port of the Ethernet switching plane:
ipmcset -l
The parameters are described as follows:
●
●
●
●
Step 5 (Optional) Configure the gateway for the switching plane by running the
following command so that the switching plane can communicate with the PC:
smmset -l swi
The parameters are described as follows:
●
●
●
●
●
Issue 20 (2020-09-25)
N :fru M -d swipcontrol
N indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M : indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
If yes, go to Step 4.
If no, go to Step 5.
<bladeN|swiN> -d ipaddr -v <ipaddr> <mask> [gateway]
N indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M : indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
ipaddress : indicates the IP address of the management network port.
maskaddress : indicates the subnet mask of the management network port.
NO TE
For stacked switching planes, configure the gateway only for the master switching plane.
N :fru M -d route -v targetvalue maskvalue gatewayvalue
N indicates the slot number of the switch module. The value range is 1 to 4,
mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right on the
panel respectively.
M : indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
targetvalue : indicates the target network segment IP address of the switching
plane.
maskvalue : indicates the subnet mask of the switching plane.
gatewayvalue : indicates the gateway IP address of the switching plane.
Copyright © Huawei Technologies Co., Ltd.
4 Collecting Information
16