Dial Access To Attendant-Ccis - NEC UNIVERGE SV9300 Networking Manual

DIAL ACCESS TO ATTENDANT-CCIS

General Description
When SV9300 is a master office or a slave office, this feature allows a station user to call an Attendant
Console by dialing an operator call code via the CCIS network.
Programming
• When SV9300 is a master office:
START
CM62 Specify the tenants to be handled by each ATT
Group.
NOTE 1:
NOTE 2:
CM20 Assign the access code for LCR Group 3
(A129).
CM8A Assign an area code table to be used to select a
route pattern table.
Assign the Route Pattern number to the Area
Code Development Pattern number assigned
by CM8A Y=A000.
A
DESCRIPTION
When marking a link with the 2400
IPX, Tenant number should be
assigned as 01-63, not 00.
A reset by CM60 Y=90>0: 0 is
required after this data setting.
• Y=0-3: ATT Group 0-3 assigned by CM60
Y=00
(1) 00-63: Tenant No.
(2) 0 : To handle
1 : Not handled
• Y=0: Number Plan Group 0-3
(1) X-XXXX
(2) A129
• Y=A000
(1) 3: LCR Group 3
(2) 4005-4007: Area Code Development Pat-
• Y=4005-4007
(1) X-X...X: Area Code (Maximum 8 digits)
(2) 0000-0255: Route Pattern No. 000-255
1-151
Chapter 1 CCIS FEATURES
DIAL ACCESS TO ATTENDANT-CCIS
DATA
tern No. 5-7
NWA-088654-001 Rev.1.0
94ch1005.fm