Overlap Sending-Q-Sig - NEC UNIVERGE SV9300 Networking Manual

OVERLAP SENDING-Q-SIG

[For EMEA/Russia]
START
CM35 Assign the Area Code Development Pattern
number for Toll Restriction and maximum dig-
it analysis to each trunk route.
Assign the Q-SIG call origination procedure.
Assign the number of division digits.
CM85 Specify the maximum number of sending dig-
its to be dialed by Calling Party.
The maximum number of sending digits in-
cluding the area codes should be assigned to
each area code.
END
DESCRIPTION
• Y=076
(1) 00-63: Trunk Route No.
(2) 00-07: Area Code Development Pattern
No. 0-7
15 : Not used
• Y=206
(1) 00-63: Trunk Route No.
(2) 0 : En-bloc call origination and overlap
call origination
1 : En-bloc call origination only
• Y=207
(1) 00-63: Trunk Route No.
(2) 00-31: 0 digit-31 digits
63 : No data
• Y=0-7 Area Code Development Pattern
No. 0-7 assigned by CM8A
Y=A000
(1) X-X...X: Area code dialed, Maximum 8
(2) 01-79: 1 digit-79 digits
24 : 24 digits
2-29
Chapter 2 Q-SIG FEATURES
OVERLAP SENDING-Q-SIG
DATA
digits
NWA-088654-001 Rev.1.0
94ch2001.fm