Outgoing Trunk Queuing-Ccis - NEC UNIVERGE SV9300 Networking Manual

OUTGOING TRUNK QUEUING-CCIS

General Description
This feature allows a CCIS network station, upon encountering an all trunks busy signal, to dial a specified
access code and enter a first-in, first-out queue. As soon as a CCIS trunk becomes available, stations in the
queue will be called back on a first-come, first-served basis.
NOTE: This feature applies to the tie line trunks between the two PBX systems and not to the outgoing
trunks at the remote PBX.
Programming
START
CM12 Assign Service Restriction Class A to the re-
quired stations.
CM15 Allow Outgoing Trunk Queuing in Service Re-
striction Class A assigned by CM12 Y=02.
CM20 Assign access code for setting and resetting
this service.
CM90 Assign the Trunk Queuing-OG (Call Back)
key to the required Multiline Terminal.
CM35 Specify the Trunk Queuing-Outgoing capabil-
ity to each trunk route.
END
DESCRIPTION
• Y=02
(1) X-XXXXXXXX: Station No.
(2) XX ZZ
XX: 00-15 : Service Restriction Class A
• Y=002
(1) 00-15: Service Restriction Class A as-
signed by CM12 Y=02
(2) 1 : Allow
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) A004: Set
A005: Reset
• Y=00
(1) My Line No. +
(2) F0004
• Y=028
(1) 00-63: Trunk Route No.
(2) 0 : Restricted
1 : Allow
1-207
Chapter 1 CCIS FEATURES
OUTGOING TRUNK QUEUING-CCIS
DATA
,
+ Key No.
NWA-088654-001 Rev.1.0
94ch1006.fm