Voice Call-Ccis - NEC UNIVERGE SV9300 Networking Manual

VOICE CALL-CCIS

General Description
This feature provides a voice path, through the CCIS network, between a Multiline Terminal in one office
and a Multiline Terminal in another office. This path is established from the calling party to the called par-
ty's built-in speaker. If the called party's MIC lamp is on, the called party can have a conversation in
hands-free.
Programming
START
CM90 Assign a Voice Call key to the Multiline Termi-
nal.
END
Operating Procedure
From a Multiline Terminal to another Multiline Terminal:
1. The originating Multiline Terminal user dials the desired station number in another office, and re-
ceives ring back tone.
2. The calling party presses the Voice Call feature key.
A signal tone is transmitted over the CCIS network to the called party's speaker.
The calling party's LCD shows:
3. The called party presses the MIC key (if the MIC lamp is not lit) to allow two-way conversation
with the calling party.
DESCRIPTION
VOICE CALL
(TIME DISPLAY)
Called Multiline Terminal
• Y=00
(1) My Line No. +
(2) F1002: Voice Call
XXXX
1-253
Chapter 1 CCIS FEATURES
VOICE CALL-CCIS
DATA
,
+ Key No.
NWA-088654-001 Rev.1.0
94ch1006.fm