How To Read This Manual - NEC UNIVERGE SV9300 Networking Manual

HOW TO READ THIS MANUAL

Chapter 1 through Chapter 3 explains the feature programming for each service about the following items.
PROGRAMMING
This section explains the programming procedure for each service.
The meanings of (1), (2) and marking are as follows.
: 1st data
(1)
(2) : 2nd data
: Default; With the system data clear command (CM00, CM01), the data with this marking is
automatically set for each command.
: A reset of the CPU blade is required after data setting.
RESET
Press RESET switch on the CPU blade.
: Command with this marking can be used only under Off-Line mode of the CPU
OFF LINE
blade. To set Off-Line mode,
(1)
(2)
: Commands which require a reset of the blade by CME0 Y=3 after data setting.
BLADE RESET
Set SENSE switch on the CPU blade to "E" or "F".
Press RESET switch on the CPU blade.
6
INTRODUCTION
HOW TO READ THIS MANUAL
NWA-088654-001 Rev.1.0
94ch0001.fm