Programming Procedure - NEC UNIVERGE SV9300 Networking Manual

PROGRAMMING PROCEDURE

For the Remote UNIT over IP data, there are three types of system data as shown below.
Program the system data according to each of programming procedure.
• System data set to the CPU blade of Main Unit
(1) Data for Main Unit Operation
(2) Data for Remote Unit Operation
• System data set to the CPU blade of Remote Unit
• System data set to the CPU blades both of Main Unit and Remote Unit
(1) VoIPDB Data
NOTE:
LAN Data for Main Unit and Remote Unit must be set to the CPU blades both of Main Unit
and Remote Unit when an additional Remote Unit is installed.
Chapter 3 REMOTE UNIT OVER IP FEATURES
3-23
PROGRAMMING PROCEDURE
NOTE
NWA-088654-001 Rev.1.0
94ch3001.fm