Digital Trunk Data Assignment - NEC UNIVERGE SV9300 Networking Manual

Digital Trunk Data Assignment

START
CM05 Assign a Unit number and Slot number to the
CCT blade.
Assign the Trunk blade number to the CCT
blade.
CM10 Assign a trunk number for a common signal-
ling channel and voice channels to the CCT
blade.
CM04 Assign the destination to receive the synchro-
nous signal for CCT.
NOTE 1:
NOTE 2:
NOTE 3:
A
DESCRIPTION
BLADE RESET
BLADE RESET
BLADE RESET
This data is assigned for the clock synchronization of SV9300 for the opposite office of
ISDN network/CCIS/Digital Tie Line. Do not assign this data for ISDN terminals.
The second data must be assigned the Slot number to which each interface blade (PRT/
BRT/CCT/DTI) is accommodated (the first data 01 [first priority] is mandatory. Do not as-
sign the first data 02 [second priority] only).
The connection to a SIP conversion adapter with BRT/PRT blade depends on whether the
adapter can supply the clock or not. Do not assign this data for the BRT/PRT blade when
the clock cannot be supplied.
• Y=0
(1) XX ZZ
XX: 01-50: Unit No.
ZZ : 01-18: Slot No.
(2) 42: CCT blade
• Y=1
(1) XX ZZ
XX: 01-50: Unit No.
ZZ : 01-18: Slot No.
(2) 000-127 : Trunk Blade No.
NONE : No data
• Y=00
(1) XX YY ZZ: Physical Port No.
XX: 01-50: Unit No.
YY: 01-18: Slot No.
RESET
ZZ : 01-24: Circuit No. of 24 CCT
ZZ : 01-31: Circuit No. of 30 CCT
(2) D000-D511: Trunk No.
• Y=10-59
(1) 01: First priority
02: Second priority
(2) 01-18
NONE : No data
1-38
Chapter 1 CCIS FEATURES
CCIS BASIC PROGRAMMING
DATA
: Slot No.
NWA-088654-001 Rev.1.0
94ch1002.fm